To determine the amount of paint required, we divide the surface area by the coverage rate per liter and subsequently multiply the result by the number of coats needed.
Based on the product we will suggest the number of coats that you'll need.
We recommend this number of paint coats to ensure the best results.
36hr Recoat Time
7Days Full Dry Time
Coverage: 1 m2 / Ltr
Breathable Allow substrates to breath moistureFor concrete and mozaic tiles surfaces.
• Apply one coat of "Jazeera Roof Protection" as a primer after thinning (30-40) % water using roller.
• Install "Jazeera Titex Mish" by using "Jazeera Roof Protection" on corners, pipes and drainage.
• Apply 1 coats of "Jazeera Roof Protection” 500µ by roller after that install "Jazeera Titex Mish" then Apply another coat of "Jazeera Roof
Protection" 500µ by roller and continue for full area.
For steel surfaces:
• Apply one coat of "Jazeera Roof Protection" thickness 75µ as a primer after thinning (10-15) % water using airless spray
• Install "Jazeera Titex Mish" by using "Al-Jazeera Roof Protection ” on steel sheets joint which in the path of drainge water.
• Apply 2 coats of “ Jazeera Roof Protection ” 500µ by airless spray.
For polyurethane foam surfaces:
• Install “Al-Jazeera Titex Mish” by using "Jazeera Roof Protection" on corners and big holes.
• Apply 2 coats of "Jazeera Roof Protection" 500µ by roller.
• Airless spray: Nozzle Orifice : "0.017-0.021"
Nozzle Pressure : 15 MPa ( 2100psi)
Spray Angle : 40-60°
• Roller :(Recommended type: Dekor Nardeen 8009 - code:1093)
• Brush: Recommended type. for narrow areas
For cement Tiles:
• The surface must be clean, dry, free from dust, oil, grease, salt, mold and protrusions.
For concrete and masonry surfaces:
• The concrete must be fully cured for 28 days.
• The surface must be treated by removing all forms release agents and protrusions to get a suitable surface for application.
• Make sure that the surface is sound, clean, free from dust, oil, greases, salt and mold.
• Fill cracks and holes by “Jaz Epoxy Crack Filler ESP”.
For steel surfaces:
• The surface must be sound, clean, dry, free from corrosion, dust, oil, grease and salt.
• "Jazeera Epo-mastic" should be applied on the rusted areas after suitable preparation.
• All holes shall be filled by a suitable sealant.
For polyurethane foam surfaces:
• The surface must be clean, dry and free from dust, oil, grease, salt and mold.
